Planning to retire

[UMike]

Very deceiving photo.
In Colombo. So bored after one day I went and hired a motorcycle (after the Dons speech).
Almost sold some CSL so we'll see how is goes.
Internet wifi is really bad. Phones ok though.

 

[UMike]

Beating the market 7 weeks in a row now. .
Just sold a portion of CSL.
Feeling thankful in a country that is so poor.
(Probably get run over by a truck tomorrow. )

 

[UMike]

 

[UMike]

So planning to again retire.

Took on a last project setting up a production line in Thailand.

Granted my German mentality doesn't suit Thai Standards and ethics but then again I didn't expect it too.
Even allowing for this I can't make it work so looking forward to freeing myself up from all commitments.

Just putting it out there.

 

[moXJO]

So planning to again retire.

Took on a last project setting up a production line in Thailand.

Granted my German mentality doesn't suit Thai Standards and ethics but then again I didn't expect it too.
Even allowing for this I can't make it work so looking forward to freeing myself up from all commitments.

Just putting it out there.

God that would be a tough post for a German
Thai dudes tend to do it how they want.
Was it just not doable?

 

[UMike]

God that would be a tough post for a German
Thai dudes tend to do it how they want.
Was it just not doable?

We are making parts for machines making Semiconductors.
Sample Parts have been made and sent off for evaluation.
The company mainly make cabinets, Trailers and other fabricated products.
They just don't have the correct mindset for High quality scientific parts, and I am not going to hold the can when they fail.

I'm offering to stay and train my replacement but haven't heard back.
Headquarters is in Australia and I have sort advice from a few key people who know me. I want to be sure to maintain my reputation and from cooler heads know if there was anything else I could do approach wise.

Pity.

 

[moXJO]

We are making parts for machines making Semiconductors.
Sample Parts have been made and sent off for evaluation.
The company mainly make cabinets, Trailers and other fabricated products.
They just don't have the correct mindset for High quality scientific parts, and I am not going to hold the can when they fail.

I'm offering to stay and train my replacement but haven't heard back.
Headquarters is in Australia and I have sort advice from a few key people who know me. I want to be sure to maintain my reputation and from cooler heads know if there was anything else I could do approach wise.

Pity.

Those machine parts (depending on what it is) are some of the most complex devices ever built. Unless it's easy like a bunch of hepa filters good luck.

Just go steal some Malaysians.

 

[UMike]

Those machine parts (depending on what it is) are some of the most complex devices ever built. Unless it's easy like a bunch of hepa filters good luck.

Just go steal some Malaysians.

It is actually management.

The actual setup is supposed to be modern fixture based. (Even automated eventually). Not the hard arsed manual loading of the past.

Thias are fine.... But give me some Vietnamese for this any time,

 

[moXJO]

It is actually management.

The actual setup is supposed to be modern fixture based. (Even automated eventually). Not the hard arsed manual loading of the past.

Thias are fine.... But give me some Vietnamese for this any time,

Thai guys can be stubborn. I always found that Thai women running a business were more likely to listen.