- Joined
- 10 April 2009
- Posts
- 12
- Reactions
- 0
CKK has the technology for a drill for Geothermal or Oil drilling that is vastly superior to current technology.
At the risk of sounding like a badly written Brochure, here's my summary of CKK's drill.
Dare I compare it to MHM in that is has industry changing technology potential, on all parameters the GT3000 (CKK's drill) outperforms conventional drills, including fuel efficiency, replacement of drill bits (these can individually run into the tens of thousands), number of operators required etc, to even the size of the thing, takes much less money and time to mobilize. The actual drill can switch between air hammer and conventional drilling, with air hammer faster for softer ground (if I recall correctly), and the ability to switch between the two modes rapidly, CKK's drill can drill a the same distance for less time and cost, both on average and in total.
The cost of construction one GT3000 is approximately 3.3 million according to company documents, with revenue of approx 14 million for contracting it at a 50% utilization rate out that's over a 300% return p.a. on money invested.
I hope I've got whoever reads this interested in CKK's story, as opposed to mindlessly buying it due to some kid on the net writing about it, DYOR and you'll probably come to the same conclusions as me (if not don't buy, no hard feelings).
This really sounds too good to be true, and it just might be (firepower etc come to mind) so if you do end up investing, keep it to a smallish spec level, not an all in.
This really sounds too good to be true, and it just might be (firepower etc come to mind) so if you do end up investing, keep it to a smallish spec level, not an all in Parelvouz
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?